![]() ![]() See our Online Catalog for all of our Stitch and Glue Designs. See our Stitch-N-Glue Pictorial Guide with captions for further details. Final stitching, filleting, and finishing is done the same as on our other Stitch-N-Glue designs.Īll FAST-G plans feature patterns for virtually every contoured part in the boat….and that’s a lot of templates. Since the panels are developed for sheet material, the planking folds readily into shape without undue effort. FAST-G Plans and Patterns supply templates for all planking. Then the boat is folded together to form the vee bottom hull. The planking is assembled flat on the ground. Remember when you were a kid in school? The map of the world, even though it is round, was shown flat on the pages of the geography book with various gores of cut outs. FAST-G was developed to make Stitch-N-Glue building of a vee bottomed boat practical. All patterns are reproduced either as full or symmetrical half-section patterns, and include all planking members.įAST-G….Fold And Stitch Then Glue. In addition, the Full Size Patterns provided with all Stitch-N-Glue designs are precise since they’re taken from the actual panels used to build our prototype boats. Plans packages for Stitch-N-Glue designs include instructions, material layouts, and material listings. The resulting boat is incredibly light weight, strong, and durable. Stitch-and-glue boat building is not only stronger, lighter, and faster than traditional wooden boat building, but it also takes far less skill. A hand saber saw and drill are about the only power tools required. The stitch-and-glue Petrel is a Greenland-style. A range of comfortably stable and manoeuvrable cedar-strip sea kayaks with good all-around performance, efficient for making open water crossings yet responsive when close to shore. This method eliminates many members that ordinarily require fitting, fairing, and bevelling. Plans for building your own wooden kayak from scratch using the stitch-and-glue or cedar-strip method. Just about anybody can build a boat using the GLEN-L Stitch-N-Glue system. The stitched and glued seam is then covered with strips of resin-coated fiberglass tape inside and out. The glue is an epoxy putty formed in a cove-shaped fillet along the seams, usually on the inside. These are twisted together to hold the panels together. The stitching is done with short lengths of copper wire passed through small holes along seam edges. Such a boat can be assembled in a matter of hours after cutting out the parts. This quick and easy boatbuilding method consists of plywood planking panels cut to shape from full-size patterns which are “stitched” and “glued” together at the seams. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |